#WHO HAS A TEN TEC TRITON IV FOR SALE INSTALL#
#WHO HAS A TEN TEC TRITON IV FOR SALE CRACK#

The violet wire will be used later with the digital frequencyД¬) Pretesting and Mounting the ControllerД«efore installing, ensure that your DDS VFO board works The white and green leads as it is required in the preamp circuit. You decide to remove both sockets, reconnect the 2.2K resistor between The crystal calibrator from the Triton, making room The output of the DDS VFO ( described later). The white wires alone as they will be connected to Orange and brown wiresВ connected to the P/C board are removed.

Unsolder the 4 wires from the PTO (white, green, orange and brown).

Side screws (may require the temporary removal of a circuitД«) Removing the PTO and Crystal Calibrator The two front panel screws holding the PTO in place.

Remove and discard the dial cord, the pointer and any thing else associated with the slide rule tuning mechanism.

Slide the panel forward, unplugging the small connector that provides power

Remove the 2 bottom screws holding the front panel.

Knobs (like the PTO tuning) require a very small (.05) In some cases, it may be necessary to remove theД«andswitch requires a small slotted screwdriver.

#WHO HAS A TEN TEC TRITON IV FOR SALE CRACK#

Slight crack in the silver colored solder with a sliver of brightД¬opper underneath, and these may be repaired with a fine tipped The contacts, one can usually see the intermittent which looks like a

Use, some of these connections might be intermittent. You might want to check the soldered joints on the Mixer boad where theД«andswitch contacts are soldered. Then, apply deoxit (or equivalent) to theД«andswitch contacts and rotate them back and forth several times. Triton without the octal plug in the rear panel, you'll need to strap 4ДЄnd 5 together, and pins 6,7 and 8 together. It would be wise toВ ensure that your radio is working, sparing To save a lot of frustration and possible You'llВ note that the speaker connection coax is rather shortДЄnd has not been provided with a quick disconnect Mount an Almost All Digital Electronics DFD1A device within the radio and on the front panel ( more later). Possibly find a used external Ten-Tec digital display, I decided to The slide rule dial will all be gone - removed! While one could If you plan to undertake this conversion, you'll need some form ofДigital frequency display as the PTO, the circular frequency marker and The Analog Triton (540) does not have an internal digital frequency display. Conversion Suggestions - Ten-Tec Triton 540 Radio Here are pictures of the schematic, the P/C board 2 artwork, the wire connection points and a completed assembly.ДЈ. The P/C boards have been designed so that the Chinese AD9850 DDSД«oard can be soldered right to it. Either is totally satisfactory and there are most often economical choices on eBay.

A 256 step encoder will double this to 10 khz. Note: a 128 step optical encoder will enable a frequency excuirstion of about 5 khz for each complete rotation.

#WHO HAS A TEN TEC TRITON IV FOR SALE INSTALL#

However, if the user is willing to install a home brew digitalДisplay,В other Ten-Tec radios like the analog Century 21, theД¬entury 22 or the early Argonauts could likewise reap the benefits of Installed in other Ten-Tec radios including the Corsair I andД¬orsair II, the 'Omni's', the Delta, the Argosy II and the DigitalД¬entury 21 as these radios are all equipped with a factory stock This site currently describes how this DDS VFO can improveВ the

Other Triton Information / Modifications.

Who has a ten tec triton iv for sale